• This heat pad may only be used in conjunction with the controller
specified on the label.
• This heat pad must only be connected to the mains voltage that is
specified on the label.
• The electrical and magnetic fields emitted by this heat pad may
interfere with the function of a pacemaker. However, they are
still well below the limits: electrical field strength: max. 5000 V/m,
magnetic field strength: max. 80 A/m, magnetic flux density:
max. 0.1 millitesla. Please therefore consult your doctor and the
manufacturer of your pacemaker before using this heat pad.
• Do not pull, twist or make sharp bends in the cables.
• If they are not positioned properly, there may be a risk of becoming
entangled in, being strangled by, tripping over, or stepping on the
cable and controller of the heat pad. The user must ensure that
excess lengths of cable, and cables in general, are safely routed.
• Please check this heat pad frequently for signs of wear and tear
or damage. If any such signs are evident, if the heat pad has been
used incorrectly or if it no longer heats up, it must be checked by
the manufacturer before being switched on again.
• Under no circumstances should you open or repair the heat pad
(including the accessories) yourself because faultless functionality
can no longer be guaranteed thereafter. Failure to observe this will
invalidate the warranty.
• If the mains connection cable of this heat pad is damaged, it must
be disposed of. If it cannot be removed, the heat pad must be
disposed of.
• When this heat pad is switched on:
– Do not place any sharp objects on it
– Do not place any heat sources, such as hot water bottles, heat
pads or similar, on it.
• The electronic components in the controller warm up when the
heat pad is in use. For this reason, the controller must never be
covered or placed on the heat pad when it is in use.
• It is essential to observe the information relating to the following
chapters: Operation, Cleaning and maintenance, Storage.
EN - 15
