6 Raffles Boulevard #03-308 Marina Square Singapore 039594
T: 6702 3075 E:
innovation@tomalglobal.com
W:
www.tomalglobal.com
3.
Installation steps:
a.
Open the package and check if the whole machine is complete and whether
the accessories are complete.
b.
Drill holes in the appropriate position on the wall, install expansion screws.
c.
Cut the PE pipe to the required length and connect the water source to the
machine inlet with a PE pipe.
d.
Hang the installed machine on the expansion screw on the wall.
Flushing system before use
After installation, plug the power plug of this unit into the socket (make sure that the power
switch and the cooling switch of the unit are placed in the “off” state before plugging in.) Turn
on the power switch to replenish the water in the machine. After the water is supplied to the
standby unit, unplug the drain plug, drain the water, clean out the water, and cover the drain.
Repeat 1-3 times.
After cleaning, touch or press the “ambient/cool water” button to start operation when there
is continuous water flow out of the water outlet.
Dispensing Water
a.
To turn on the dispenser, turn on the RED switch on the side panel, and the whole
machine will enter the standby state.
b.
For dispensing hot water, first touch on “Safety Lock” to unlock. Then, touch on
either “Hot (1 cup)” or “Hot (2 Cup)” to dispense the Hot Water.
(
Caution:
Please use extra care and do not move the cup away when the hot water is
being dispensed. To stop the water, touch the same button and the water flow will
stop within 5 seconds).
c.
For dispensing ambient or cool Water
,
make sure the Green Switch on the side is
turned on. When it is first switched on, the machine will enter into its cooling state.
When the machine has reached the set value, the machine stops cooling and enters
preservation state. This might take up to 10 mins when the switch is first turned on.
When the cooling switch is turned off, the cooling function will be turned off.
d.
When the machine is in abnormal operation, the machine will display E0 or E1 fault
code with an alarm prompt.
Wall
Hanging board
Plastic
Expansion
Self-tapping
Screw
Inlet Joint
position
PEpipe location
*Reset Switch
