PAGE 10
6. WHEN BOTH BRUSHES ARE ENGAGED REPLACE
THE BRUSH ACCESS DOOR AND TIGHTEN IT BACK
DOWN WITH THE WINGNUTS.
(SEE FIGURE 15.)
***
FOR CORRECT PAD APPLICATION , CALL YOUR LOCAL DEALER
***
ATTACHING
CYLINDRICAL BRUSHES
1. TURN ON MACHINE POWER
2. RAISE THE SCRUB DECK BY DEPRESSING THE
BRUSH SWITCH TO THE UP AND OFF POSITION
AND TURN MACHINE POWER BACK OFF.
(
SEE FIGURE 10.
)
3. OPEN THE SIDE DOOR TO ACCESS CYLINDRICAL
SCRUB DECK
4. UNSCREW THE THREE WINGNUTS ON THE BRUSH
ACCESS DOOR AND REMOVE THE DOOR.
(SEE FIGURE 13.)
ATTACHING
DISK BRUSHES
1. TURN ON MACHINE POWER
2. RAISE THE SCRUB DECK BY DEPRESSING THE
BRUSH SWITCH TO THE UP AND OFF POSITION
AND TURN MACHINE POWER BACK OFF.
(SEE FIGURE 10.)
7. LIFT UP ON THE WIPERS FIRST TO CLOSE SIDE
DOOR AND DEPRESS THE LATCH UNTIL THE DOOR
IS SECURED.
(SEE FIGURE 12.)
3. OPEN SIDE DOOR TO ACCESS SCRUB DECK
4. SELECT THE CORRECT PADS OR BRUSHES THAT
BEST MEET YOUR CLEANING APPLICATION.
CONSULT YOUR LOCAL DEALER FOR ASSISTANCE.
5.
PAD INSTALLATION
ATTACH PADS TO PAD
DRIVERS BEFORE CONNECTING DRIVERS TO
MOTOR HUB.
6. ATTACH BRUSHES OR PADS TO MOTOR HUBS.
SQUEEZE THE SCISSOR LOCKING DEVICE AND LIFT
BRUSH UP ON TO THE MOTOR DRIVE HUB. MAKE
SURE THE SCISSORS CLOSE AND LOCK ONCE THE
BRUSHES ARE ON.
(SEE FIGURE 11.)
5. SLIDE THE BRUSHES IN ONE AT A TIME. WHEN YOU
GET THE BRUSH ON THE DRIVER SPIN IT WITH YOUR
HAND UNTIL YOU FEEL IT ENGAGE AND DROP IN.
(SEE FIGURE 14.
)
7. LIFT UP ON THE WIPERS FIRST TO CLOSE SIDE
DOOR AND DEPRESS THE LATCH UNTIL THE DOOR
IS SECURED.
(SEE FIGURE 12.)
FIGURE 10.
FIGURE 11.
FIGURE 12.
FIGURE 13.
FIGURE 14.
FIGURE 15.
chadv
11/23/2005 9:54:13 AM
