PAGE 11
ONE PASS SCRUBBING
STEPS: (SEE FIGURE 17.)
1. TURN MACHINE ON WITH THE KEY SWITCH.
2. LOWER SQUEEGEE BY PRESSING THE SWITCH.
3. LOWER SCRUB HEAD TO THE FLOOR, USE THE
TOP HALF (+) OF THE BRUSH SWITCH.
4. TURN ON THE SOLUTION SWITCH AND ADJUST
THE SOLUTION LEVER TO THE DESIRED SETTING.
5. BEGIN SCRUBBING BY DEPRESSING THE
FOOT PEDAL SLOWLY AND THEN TO THE
SPEED REQUIRED, THE HEADLIGHT
SHOULD ILLUMINATE.
6. ONCE THE MACHINE BEGINS TO MOVE,
CHECK THE DOWN PRESSURE GAUGE. START
SCRUBBING AT THE #1 OR # 2 MARKS, DO NOT
USE THE #4 OR #5 MARKS WITHOUT
MANAGEMENTS APPROVAL.
7. TO OPERATE MACHINE IN REVERSE,
SIMPLY SWITCH THE REVERSE SWITCH TO
THE REVERSE POSITION, BACK UP ALARM
MAY SOUND AND YOUR REV SPEED IS SET
TO ROUGHLY 50% OF FORWARD.
8. TO STOP THE MACHINE, LET OFF OF THE
FOOT PEDAL, AND THE MACHINE WILL
STOP AUTOMATICALLY.
OPERATION
PRE-CLEANING CHECK LIST
READ AND UNDERSTAND THE SAFETY SECTION ON
PAGE 5 AND 6 BEFORE OPERATING MACHINE.
1. CHECK BATTERY CONDITION GAUGE ON
THE CENTRAL COMMAND II LCD SCREEN.
TO CHECK GAUGE PUSH MENU CONTROL
BUTTON UNTIL BATTERY GUAGE APPEARS.
MAKE SURE BATTERIES ARE FULLY CHARGED
BEFORE USING.
2. CHECK THE CONDITION OF PADS OR BRUSHES.
3. CHECK THE CONDITION OF THE SQUEEGEE BLADES.
4. TRANSPORT THE MACHINE TO THE FILLING
STATION. RAISE THE SCRUBHEAD AND
SQUEEGEE WHEN TRANSPORTING.
5. TURN MACHINE OFF.
6. OPEN SOLUTION FILL DOOR AT THE SIDE OF
THE MACHINE AND FILL THE TANK WITH UP
TO 38 GALLONS OF CLEAN WATER. THE
CLEAR TUBE AT THE FRONT OF THE MACHINE INDICATES
THE AMOUNT OF WATER IN THE TANK.
7. ADD CLEANING CHEMICAL. USE THE PROPER
DILUTION RATIO INDICATED ON THE BOTTLE.
NOTE:
USE ONLY NONFLAMMABLE COMMERCIAL
CLEANING CHEMICALS. YOUR AUTHORIZED
DISTRIBUTOR CAN ASSIST YOU IN SELECTING A
PROPER CHEMICAL.
1
2
3
4
5
4
7
6
FIGURE 16.
FIGURE 17.
chadv
11/23/2005 9:54:13 AM
