PAGE 14
MONTHLY
MAINTENANCE
1. CHECK SCRUB HEAD AND SQUEEGEE LIFTING CABLES FOR
WEAR AND SPRING TENSION.
2. CHECK MACHINE FOR WATER LEAKS AND LOOSE NUTS AND
BOLTS.
3. CHECK TO SEE IF BATTERY CABLES ARE TIGHTENED
(TIGHTEN IF NEEDED)
4. CHECK PARKING BRAKE
5. CHECK CONDITION OF SCRUB DECK LIFTING CABLE.
YEARLY
MAINTENANCE
1. CALL YOUR LOCAL DEALER FOR YEARLY MAINTENANCE
STORING MACHINE
1. BE SURE TO FLUSH THE TANKS OUT COMPLETELY, AND TO
DRAIN ALL WATER FROM THE MACHINE.
2. REMOVE THE RECOVERY TANK LID TO PROMOTE AIR
CIRCULATION.
3. RAISE BRUSHES AND SQUEEGEE.
MAINTENANCE
DAILY MAINTENANCE
1.
REMOVE AND CLEAN PADS OR BRUSHES. NEVER
USE SOILED PADS WHEN CLEANING. REPLACE
PADS WHEN THEY BECOME PACKED WITH RESIDUE.
2. REMOVE AND CLEAN DEBRIS FROM THE FLOAT
SHUT-OFF SCREEN LOCATED INSIDE THE RECOVERY
TANK.
3. DRAIN AND RINSE TANKS THOROUGHLY INSPECT
VACUUM HOSE FOR ANY OBJECTS OBSTRUCTING
THE AIR FLOW.
4. RAISE SQUEEGEE AND WIPE BLADES WITH A CLEAN
CLOTH. STORE SQUEEGEE IN THE RAISED POSITION
TO PREVENT DAMAGE OR SETTING OF THE BLADES.
5. WIPE DOWN MACHINE IF NEEDED. USE A
NONABRASIVE, NON SOLVENT CLEANER, OR A
CLEAN DAMP CLOTH.
6. RECHARGE THE BATTERIES IF NEEDED.
WEEKLY
MAINTENANCE
1. CHECK BATTERY WATER LEVEL IN EACH CELL OF THE
BATTERIES, AND FILL AS NEEDED. ALWAYS USE
DISTILLED WATER TO REFILL BATTERIES. BATTERIES
SHOULD BE FILLED APPROXIMATELY 3/4" TO 1" ABOVE
THE PLATES. OVERFILLING WILL CAUSE THE BATTERIES
TO LEAK DURING CHARGING. THE CHARGING
PROCESS CREATES GAS BUBBLES INSIDE THE BATTERY,
WHICH EFFECTIVELY INCREASES THE VOLUME OF THE
ELECTROLITE.
2. CLEAN BATTERY TOPS TO PREVENT CORROSION.
3. ROTATE BRUSHES. ROTATE THE LEFT TO THE RIGHT
AND RIGHT TO LEFT. ON CYLINDRICAL MODELS
FROM FRONT TO BACK, OR END TO END IF USING
DIFFERENT MATERIALS.
chadv
11/23/2005 9:54:13 AM
