GT-OP-EN
- 7 -
OPERATION CONTROLS
1.
HANDLEBAR ADJUSTMENT CLAMPS:
Loosen clamps to adjust the total height of the handlebar
2.
RECHARGE CYCLE METER:
Shows the amount of charges on a machine
3.
MAIN BROOM POSITION LEVER:
Controls whether the Main Broom is UP (Lever to the left) or Main
Broom is DOWN (Lever to the right)
4.
MAIN POWER OFF/MAIN/SIDEBROOM SWITCH:
Controls what on the machine has power - If in the
middle position, only Main Broom has power while in the top position the Side Broom has power as well
5.
BATTERY GAUGE / HOUR METER:
Indicates the amount of battery charge remaining along with total
hours used
6.
CLUTCH AND BRAKE LEVER:
Pulling on the lever engages the clutch wheel to drive Rear Wheels
and lowering the lever engages the Brake
7.
ADJUSTABLE HANDLEBAR:
Handlebars being adjustable by loosening and lowering or raising the
full handlbar piece allows Operators of any height to operator the machine comfortably
8
.
CLUTCH AND BRAKE CABLE ADJUSTMENT:
The Clutch and Brake operator with the same control
and by way of the same clutch donut - for adjusting see Clutch and Brake Adjustment
9.
HOOD LATCH:
Locks the hood down in place - Release to gain access underneath the hood
10.
SIDE BROOM POSITION LEVER:
Contols whether the Side Broom is UP (Lever to the right) or Side
Broom is DOWN (Lever o the left)
11.
FILTER SHAKER CRANK:
Turn the Filter Crank to clean out the fi lter before emptying the Hopper -
Crank must be vertical before reomoving or replacing the Hopper
6
7
8
9
10
11
1
2
3
4
5
