TR-OP-EN
- 13 -
INSTALLING SIDE BROOMS:
1. Lower the Side Brooms by pulling forward on the Side
Broom Level and sliding to the rear.
2. Remove the Side Brooms from the box.
3. Install the Side Brooms onto the Motor Shaft. Use the
bottom hole on the shaft to install the Clevis Pin and
Saftey Clip
(A)
(SEE BELOW)
.
4. Check Side Broom height to see if Adjustments are
needed.
ADJUSTING SIDE BROOMS:
1. To adjust Side Broom height, turn Adjustment Screws
Clockwise to raise and Counterclockwise to lower
(B)
(SEE BELOW)
.
2. The right Side Broom bristles should contact the fl oor in
a 10 o’clock to a 3 o’clock pattern when the Broom is in
motion
(C)
(SEE BELOW)
. The left Side Broom bristles
should contact the fl oor in a 9 o’clock to a 2 o’clock
pattern when the Broom is in motion
(D)
(SEE BELOW)
.
3. To raise the Side Brooms higher when in the up position,
adjust the Adjustment Arm
(E)
(SEE BELOW)
.
E
MACHINE OPERATION
A
C
D
B
PRE-CLEANING CHECKLIST:
Read and understand the Safety Messages section on Pag-
es 3 and 4 before operating the machine.
1. Check Battery Condition Gauge on the Control Panel.
Make sure Batteries are fully charged before using.
2. Check the condition of the Brooms.
3. Check to make sure Hopper is empty.
4. Disconnect Charger and close Hood.
5. Adjust the Seat and Steering Pedestal.
6. Turn the Key Switch ON and drive to the area to be
cleaned.
7. Adjust the speed of the Side Brooms to the desired
speed and confi rm the Side Brooms height is correct.
8. Lower the Main Broom and the Side Brooms.
9. Drive
slowly.
OPERATING HINTS:
1. Observe the amount of dirt/debris that the machine is
sweeping up. If dirt/debris is left on ground make sure
that the Wet Sweep By-Pass is not open. This feature
reduces dust control and should only be used when
operating on a fl oor with water on it.
2. Always operate at lower speeds when sweeping around
walls and objects. You should reduce the speed to main-
tain control when turning.
3. Change or turn over Brooms when dirty.
4. Stay clear of objects protruding from the fl oor such as
sockets, grates, etc, for they will damage the Brooms.
5. Always keep an eye on your gauges. They let you know
the status of a particular system at a glance. If your
battery gauge is reading low you must stop immediately
and recharge. Running the Batteries dead will result in
damage to the Batteries.
6. When you are ready to stop, raise the Side Brooms,
raise the Main Broom, turn
OFF
the Side Broom Switch,
turn OFF the Main Broom Switch and drive the machine
back to the charging area. Be sure to clean the Hopper
thoroughly before storing the machine.
