■This product is designed to be used for off road competition purposes only.
■This product must be installed by a qualified professional at a fully equipped workshop.
■This product is application specific. Using this product on an incorrect application may cause damaging this kit,
the engine and/or components related to them.
■When installing or removing the product please do not use unnecessary brute force as you may damage
the product or related components.
■Wear proper protections and use proper tools to avoid any human injury or engine failure during the installation.
■Do not operate the installation during the engine / exhaust components are hot.
■Check that all parts are fitted in the right places and fitted correctly to avoid any fire hazards.
This kit contains either φ53 type or φ63 type.
φ53 is for T400M TURBO, and φ63 is for T440M TURBO.
Please make sure the TOMEI Intake adapter kit included in this kit is applicable to your turbo prior to the installation.
This procedure described here is a basic instruction. Refer to the service manual for more detailed information.
Remove and install the factory turbo referring to the instruction manual of the T440M/T400M,
and install this kit in the arrangement shown below.
Check that there is no interference with anything else in each section.
After refilling engine oil, coolant and other removed auxiliary equipment referring to the
workshop service manual and turbocharger instruction manual, start the engine and check for air leaks.
Activate the Blow off Valve several times to check for signs of air leaks.
1.
1.
2.
3.
CAUTION
WARNING
1. REMOVING AND INSTALLING
2. INSTALLATION VERIFICATION
BEFORE INSTALLATION
For T400M (P/N:173031)
For T440M (P/N:173032)
Inner Diaφ53
Inner Diaφ63
φ53
φ63
Suction Pipe
※
Suction Pipe Gasket
<Tighten torque>
T=16.0-21.0N
・
m
(1.6-2.1kgm)
Suction Pipe Spacer
Air Pipe
Using the hose clamp as a guide,
cut the hose to adjust to
appropriate length.
Silicone Hose
※ Use the accessory parts of the turbo kit
3