10
VEHICLE OPERATION
Fuel
EUROSUPER 95 and two-stroke engine oil.
Your vehicle is equipped with an oil pump, which adds a specified
amount of oil to the petrol (approx. 2%). Pour two-stroke oil into the
separate oil reservoir (15, Fig. 3) - approximately 0,8 liter).
Use only high quality fully synthetic two-stroke oil.
CAUTION!
Prior to starting the engine for the first time, fill the fuel tank (24, Fig. 3)
with approx. 1 liter mixture of two-stroke oil and gasoline in the ratio of
1:50 (2%), then start the engine and let it run for at least 8 minutes in
order to allow the oil pump to fill the suction pipe.
Before this take off the oil pump cover (23, Fig. 3) and unscrew the bolt
on oil pump (A, Fig. 4) and wait till oil comes from reservoir. Tighten
the bolt.
Engine starting
Open the fuel cock (Fig. 6). Note: A – fuel supply shot, B – fuel supply
on, C - reserve.
If the engine is cold, press the cold start lever (B, Fig. 7).
Kick start version:
With the throttle fully closed, press the rear brake lever and press the
kick-starter lever (26, Fig. 3) – without opening the throttle.
If starting the engine when it is still warm, the throttle must be fully
opened.
Pedal version:
With the throttle fully closed, press the rear brake lever and press the
pedals (26, Fig. 3) backwards – without opening the throttle.
If starting the engine when it is still warm, the throttle must be fully
opened.
Electric starter version:
Enter the key in the ignition switch (17, Fig. 3) and turn it to the ON
position. Switch on the stop switch (6, Fig. 5). With the throttle fully
closed, press the rear brake lever and press electric start pushbutton
(7, Fig. 5).
