17
Important
: Use the strips only in combination with the holder. Do NOT place the strips on
the serial number sticker of the device.
5. Remove the protective film from the other side of both strips.
6. Place the holder with the adhesive strips on the prepared surface. Press it gently for a
few seconds until it sticks.
Note
: The full strength of the strips will be reached after approximately 72 hours
depending on the temperature.
7. Insert the LINK 510 into the holder. Press gently until it clicks into place.
Attaching the holder using the self-tapping screws
You can use the two self-tapping screws to fix the holder to your vehicle.
1. Choose a flat surface for the LINK 510.
Remember, when the LINK 510 is in the holder, it must not be obstructed by metal
objects.
2. Insert the two screws into the corresponding holes in the holder.
3. Tighten the screws.
4. Carefully place the LINK 510 in the holder until it clicks into place.
Attaching the holder using the cable ties
You can use the two cable ties to fix the holder to your vehicle. Using cable ties might have
an impact on the accuracy of the driving event reporting if the device is not fixed properly.
1. Choose a position where the LINK 510 is not obstructed by metal objects when it is in
the holder.
2. Insert the cable ties into the corresponding holes in the holder.
3. Wrap the cable ties around the object where you want to place the holder.
4. Pull the cable ties through the corresponding holes of the holder and insert them in the
in the noose at the other end of the cable ties.
