98
Tip
: For decimal values you don't have to use a letter to indicate the latitude and longitude.
For locations west of the 0 meridian and locations south of the equator, use a minus sign (-)
before the coordinate.
Degrees, minutes and seconds, for example:
N 40°43′53″ W 73°59′49″
GPS standard coordinates, for example:
N 40.77000 W -73.96855
Note
: The bar below the coordinates turns red if you enter coordinates that are not recognized by
your Rider.
5. As you type in the coordinates, suggestions are shown based on what you have entered. You can
continue typing or select a suggestion.
Tip
: To see more results, hide the keyboard or scroll down the results list.
Tip
: You can switch between seeing the results on the map or in a list by selecting the list/map
button:
6. Select a suggestion for your destination.
The location is shown on the map.
7. To plan a route to this destination, select
Drive/Ride
, depending on which device you are using.
A route is planned and then guidance to your destination begins. As soon as you start driving, the
Tip
: If your destination is in a different time zone, you see a plus (+) or a minus (-) sign and the
time difference in hours and half hours in the
. The estimated time of
arrival is the local time at your destination.
Tip
that you have already planned.
Tip
Planning a route in advance
You can plan a route in advance before you drive it. You can save the route as part of your
list.
To plan a route in advance, do the following:
1. Search for the location you want to use as a starting point.
2. Select
Show on Map
.
3. Select the pop-up menu button.
