24
Tone Commander 6210/6220 User Manual
Configure the Set _______________________
ISDN configuration is performed automatically in many cases. The
telephone set will detect the switch type, set the SPID number, and
download other setup parameters when these features are available
from the central office.
You will be prompted for any required setup information that cannot be
set automatically.
Initialization
A self-test is performed upon power up. Press any key to begin
initialization with the network. Unattended initialization begins
automatically after a short random time interval. This delay prevents
multiple terminals at a site from initializing simultaneously after a power
outage.
The display will show progress while establishing the communication
layers. When all three communication layers are established, the TEI
(Terminal Equipment Identifier) and switch type will be shown for two
seconds.
SPID Entry
The SPID number will be assigned automatically if the network
supports AutoSPID. If there is more than one SPID available for your
terminal, you will be prompted to select your primary telephone
number.
If AutoSPID is not supported, you will be prompted to enter the phone’s
primary telephone number, which is used by the phone to generate a
SPID number. Enter the number with the dial pad, then press the
Done
key. BKSP (backspace) deletes the previous digit.
National ISDN
– enter your full 10-digit telephone number
(including area code)
5ESS Custom ISDN
– enter your 7-digit telephone number
L1:OK L2:OK TEI:123
L3:OK SWITCH=5ESS NI-X
ENTER PRIMARY PHONE #
785-1243 |BKSP
