Tone PW200, Instruction Manual

15  

6. CHANGING SOCKETS 

WARNING

●

Release ejector pin by pulling ejector lever 

before changing sockets.

Accidental ejector pin release invites blindness or 

injury. 

(1) Remove inner & outer socket assembly from pneumatic 

wrench by unscrewing set screws (Figure 4).  Do not remove 
set screws completely from outer socket holder. 

  Figure 4  

(2) Remove inner socket from outer socket by pushing 

projecting pin using screwdriver or TC bolt (Figure 5). 

Figure 5  

●

 Projecting pin is a doughnut-shaped pin in the inner 

socket. 

16  

(3) Select adequate inner & outer socket assembly of the 

bolts being tightened. 

    i.e. Use TONE genuine 5/8

”

 inner & outer socket assembly 

for tightening  

5/8

”

 TC bolt/nut assembly 

(4) Place the inner socket vertically then slide the outer 

socket over the inner socket.  Push projecting pin down 
using screwdriver or pintail of the TC bolt and inner & 

outer socket will properly assembled (Figure 6). 

Figure 6  

(5) Set inner & outer socket assembly to pneumatic wrench 

body and completely remove the gap between socket assembly 
and wrench body. 

  The gap can be removed by turning & pushing down 

screwdriver or TC bolt into the inner socket. 

  
 Fasten the set screws only after gap is completely removed.