07
▪
In order to ensure the eciency and correct
functioning of the appliance, it is necessary
to follow the instructions provided by the
manufacturer and to carry out its ordinary
maintenance.
▪
The appliance shall be installed so that the
highest surface is at least 1 metre high.
▪
The appliance shall be placed on a level
horizontal surface to ensure a safe use.
▪
The temperature range of the environment
surrounding the appliance shall be included
between 5°C and 30°C. In case the appli-
ance is temporarily placed in an environ-
ment where the temperature is below 0°C,
contact a local Technical Service authorized
by the manufacturer.
▪
The machine shall be placed on a surface
guaranteeing secure support.
▪
Ideally the appliance is bolted onto the
working surface using a pair of slotted coun-
tersunk screws (M8, stainless).
▪
The machine must be connected exclu-
sively to an appropriate cold drinking water
source, in compliance with national norms
and rules. The pressure of the incoming wa-
ter must be between 0.15-0.3 MPa. If this
does not met, install a pressure reducer /
regulator according to the requirements.
▪
A shut-on tap must be installed between
machine water hose and water system to
block water flow in case of necessity.
▪
When installing the appliance, use exclu-
sively the current hose-set provided with
the appliance itself.
▪
In case of appliance breakdown and/or
malfunctioning, turn the main switch OFF
and refrain from trying to repair it. Then con-
tact a local Technical Service that has been
authorized by the manufacturer.
WARNING DUE TO
UNAUTHORISED REPAIR!
Faulty repairs can result in
damage to the appliance.
▪
Repairs should be carried out only by au-
thorised customer service centres.
▪
If you cannot correct a fault with the aid
of the steps described in these operating
instructions, please refer to your authorised
dealer.
▪
The electric safety of the machine is
achieved only when the machine is correctly
connected to a grounded electric system.
▪
The user shall arrange electric, water and
draining systems in a suitable position to al-
low correct machine installation.
WARNING BEFORE
SERVICING OR OPENING
this device make sure the
brewer is disconnected from
power by pulling its plug. The
service technician has to see
the pulled plug during the whole service
operation.
▪
The installer cannot modify the existing
system built by the user.
▪
If the electric supply plug is damaged, it
must be replaced by another plug provided
by the manufacturer or by its Technical Ser-
vice.
▪
For good machine functioning and main-
tenance, it might be necessary to install a
water softener in order to avoid scale forma-
tion. This must be evaluated by the installer
and the user shall leave a space for the cor-
rect installation of a water softener, follow-
ing the instructions contained in its manual.
Do not use water jet devices
in the area where TOUCH 03
is installed!
Do NOT tilt TOUCH 03 during
operation! Max. tilt angle < 5°.
Only to be operated by
trained personnel!
If the above-mentioned instructions are not followed, the safety and wear of the appliance can be jeopardized and its
guarantee is no longer valid.
