9
AX3G Owner’s manual
1. Set the function selector to [WRITE].
2. Press the [
▲
(WRITE)] button. The program number will blink.
3. Use the value knob or the program up/down switches to select the
program in which you want to save your settings.
4. Press the [
▲
(WRITE)] button once again. The program will be saved,
and the program/value display will indicate “
” briefly.
The newly saved program will overwrite (i.e., replace) the existing
settings, so that the previous program in that location will be lost.
If you decide not to save the new program, press the [CANCEL] but-
ton to cancel the operation.
Checking the values saved in a program (Original Value)
Bypassing the AX3G
Simultaneously press the Program Up and Program Down switches; all
effects will be bypassed. At this time, the program/value display will indi-
cate “
”.
Muting the AX3G
Simultaneously press and hold down the Program Up and Program Down
switches for about one second and the output will be muted. At this time,
the program/value display will indicate “
”.
When bypassed or muted, the Auto Chromatic Tuner will be active. To
cancel the bypass or mute function, press the Program Up or Program
Down switch (this will not change the program). At this time the value
knob will operate as the master volume.
Tuner
The AX3G has a built-in Auto Chromatic Tuner.
You can calibrate the reference pitch (the note “A”) of the tuner in a
range of A438 Hz–A445 Hz.
Tuning procedure
1. The Auto Chromatic Tuner will be activated when the AX3G is by-
passed or muted.
If you want to tune silently, such as during a live performance, simply
mute the AX3G.
2. Play a note on your guitar and the program/value display will indi-
cate the name of the closest note.
Note names are indicated as follows.
The Original Value LED in the program/
value display lets you check the parameter
values of a saved program.
When you use the knob or switches to
modify the value of a parameter, the Origi-
nal Value LED will light when that value
matches the value that’s already been saved
in the program (i.e., the original value).
In Program mode, the Original Value LED will light if the values of all
parameters match the values that are saved in the program.
Bypass and Mute
Bypass (which turns off all effects including noise reduction) and Mute
(which mutes the AX3Gs output) are convenient functions for use while
you’re adjusting your guitar amp, tuning during a live performance, or
switching guitars. Here’s how to use Bypass or Mute.
