18
7.
7.
7.
7. TROUBLE
TROUBLE
TROUBLE
TROUBLE SHOOTING
SHOOTING
SHOOTING
SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine will turn off automatically to
prevent any injuries to the user and to prevent damage to the machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power switch off, waiting for 1
minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-checking analyse (please refer
to
Self-Checking
Self-Checking
Self-Checking
Self-Checking
) to distinguish what type of error problem the machine is encountering.
7
777.1.
.1.
.1.
.1. Alarm
Alarm
Alarm
Alarm signals
signals
signals
signals and
and
and
and solutions
solutions
solutions
solutions
Before
Before
Before
Before attempting
attempting
attempting
attempting any
any
any
any work
work
work
work on
on
on
on the
the
the
the treadmill,
treadmill,
treadmill,
treadmill, ensure
ensure
ensure
ensure that
that
that
that the
the
the
the power
power
power
power is
is
is
is off
off
off
off
and
and
and
and the
the
the
the plug
plug
plug
plug is
is
is
is removed
removed
removed
removed from
from
from
from the
the
the
the power
power
power
power point.
point.
point.
point.
Do
Do
Do
Do not
not
not
not use
use
use
use extension
extension
extension
extension leads
leads
leads
leads as
as
as
as it
it
it
it may
may
may
may lead
lead
lead
lead to
to
to
to power
power
power
power decrease
decrease
decrease
decrease and
and
and
and failure.
failure.
failure.
failure.
PCB ERROR CODE AND SOLUTION
(EWAY)
ERROR CODE
PROBLEM
SOLUTION
E0
1. No safety key.
1. Put safety key.
2. Safety key sensor broken.
2. Open the meter, replace sensor
under the safety key.
3. Safety key not work.
3. Change the key.
E1
1. Motor not work.
1. Change or rework the motor.
2. Speed sensor not work.
2. Change or rework the speed
sensor.
3. Roller magnetic not work.
3. Change or rework the roller.
4. Connect wire not work.
4. Change or rework the wire.
E3:Only caused when use 'MODE'
key
1. Motor speed cannot be control.
1. Change motor.
2. Motor not work.
2. Change motor.
3. Speed sensor not work well, no
signal.
3. Change speed sensor.
7.2.
7.2.
7.2.
7.2. Problems
Problems
Problems
Problems and
and
and
and solutions
solutions
solutions
solutions
No
No
No
No display
display
display
display on
on
on
on meter
meter
meter
meter
Be sure the power is right.
- If new treadmill, be sure the connect cable all pin is right.
Summary of Contents for Homeform20
