16
FLUSH CUTTING A DOOR JAMB AND
CASING FOR INSTALLING FLOORING
–
cont’d
6. Continue to make several plunge cuts
until the bottom of the door jamb and
casing are completely cut off and the
loose pieces can be easily removed.
Follow the same basic procedure for
installing carpet, using a thicker spacer
that is the same thickness of the carpet
being installed.
CUTTING A HOLE IN WOOD FLOORING
TO INSTALL A HEATING VENT
The multi-function power tool can be used
to cut a hole in wood flooring for installing
a heating vent.
1. Install the plunge cutting saw blade for
wood in the tool (Fig. 2 Page 12 & 13).
NOTE:
The blade should be centred on
the tool housing and NOT installed in the
90° position.
2. Place the floor vent on the floor and
use a soft lead pencil to trace the
required rectangular hole (1) on the
flooring (Fig. 7).
3. Place the saw blade (2) near the floor
surface in the middle of one of the
cutting lines.
4. Turn the tool ON (Fig. 5 Page 14).
NOTE:
The tool and blade should be at a
45° angle to the floor to allow the corner of
the blade to plunge cut into the flooring.
ASSEMBLY AND OPERATING
Fig. 7
Summary of Contents for 241-8501
Page 11: ...11 CONTENTS ...
Page 20: ...20 EXPLODED VIEW ...