This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2019 by Conrad Electronic SE.
*1933084_v1_0419_02_dh_m_en
Installation
The lamp arms
(4)
and
(5)
are spring loaded, open carefully when removing from
packaging.
Do not use force to over tighten the clamp screw
(10)
as this may damage the base
clamp
(9)
and surface it is attached to.
Ensure that the surface attached to the desk clamp has parallel edges. The desk
clamp must not be attached to desks with chamfered or tapered edges.
Make sure the lamp is securely held in place before letting go.
The jaws on the base clamp
(9)
may leave marks or scratch sensitive surfaces.
Attach the base clamp
(9)
to a suitable horizontal surface (e.g. table, work bench).
a) Attach Clamp
•
Loosen the clamp screw
(10)
.
•
Slide the clamp onto the horizontal surface.
•
Tighten the clamp screw.
b) Connect Lamp to Base
•
Insert the lamp attachment plug
(7)
into the clamp socket
(8)
.
•
Gently check to make sure the connection is secure before letting go.
Operation
The upper arm
(4)
and lower arm
(5)
are spring loaded and can be adjusted within
the specified ranges. Make sure not to trap your fingers and hands when adjusting
them.
Over adjusting or using excessive force may cause damage.
Please hold the base clamp
(9)
while making adjustments to prevent the lamp from
falling over.
•
Connect the power adaptor cable to the DC input jack
(6)
and the other end to a mains power
supply.
•
Flip the lens cover
(1)
open.
•
Adjust the lamp head to the desired position.
•
Close the lens cover
(1)
after use.
a) Light control panel
There are three touch buttons
(15)
to control lighting.
Icon
Description
Superbright
: Touch to turn ON/OFF.
Ring light
: Touch to turn ON/OFF. Touch and hold to increase /
decrease brightness levels.
UV
Ultra Violet
: Touch to turn ON/OFF.
b)
Increase magnification
To increase magnification, close the lens cover
(1)
and view the object through the large
(11)
and small lens
(2)
at the same time.
Care and cleaning
•
Always disconnect the product from the power supply before cleaning it.
•
Remove loose particles from the lens with clean compressed air.
•
Clean the surface of the lens with a lens cloth or a soft, lint-free cloth.
•
Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could
damage the housing or stop the product from functioning properly.
•
Avoid excessive cleaning and applying too much pressure to the housing and lens.
Disposal
Electronic devices are recyclable waste and must not be placed in household
waste. At the end of its service life, dispose of the product according to the relevant
statutory regulations.
You thus fulfill your statutory obligations and contribute to protection of the
environment.
Technical data
a) General
Operating voltage ......................... 12 V/DC, max 11 W
Material ......................................... Lamp: ABS, PC, Iron,
Clamp: Aluminum alloy
Protection class ............................ III
Clamp range ................................. min. 12 mm, max. 62 mm
Dimmable ..................................... Yes
Energy efficiency class ................. (A to A++)
Light controls ................................ Capacitive touch
Lens material ................................
Glass
Main lens ...................................... ø133 mm, 3D (1.75x)
Main + small lens .......................... ø56 mm, 15D (4.75x)
Operating conditions ..................... 10 to 40 °C, 0 – 85 % relative humidity
Storage conditions ........................ 0 to 50 °C, 0 – 85 % relative humidity
Dimensions (LxWxH) .................... 210 x 1210 x 200 mm
Weight .......................................... 2.28 kg (main unit)
333 g (clamp)
72 g (adapter)
b) LED
Superbright
Quantity ........................................
1 pc
Brightness ..................................... 100 lm
Color temperature ......................... 6000 - 6500 K
Life ................................................ 25000 h
Power ...........................................
1 W
Ring light
Quantity ........................................
81 pcs
Brightness ..................................... 1000 lm
Lux ................................................ 4000 lux (magnifier glass focal length)
Colour temperature ....................... 6000 - 6500 K
Life ................................................ 25000 h
Power ........................................... 8.5 W
Ultra violet
Quantity ........................................
6 pcs
Brightness ..................................... 800 mcd
Life ................................................ 25000 h
Power ........................................... 0.4 W
c) Power adapter
Input voltage/current ..................... 100 - 240 V/AC, 50/60 Hz
Output voltage/current .................. 12 V/DC, 1000 mA
