42
“Languages”
Select the display language.
“Unit”
Set the temperature unit to °C (degrees Celsius, default setting) or °F (degrees Fahrenheit).
“Password”
After selecting this menu option, enter a three-digit password (000...999). Use the “
“ or “
“ buttons to change
the digits; press the MENU/ENTER button to switch to the next digit. The password will be automatically saved after
you enter the third digit.
Write down the password and store it in a safe place to ensure that you can access the menu!
To disable the password function, you will need to re-enter the password in the menu. Start by accessing the menu
(see section 10a). The password is required to access the menu. Select the password function from the system menu
and enter the same password again. The password function will then be disabled.
To change the password (e.g. from “111” to “999”), you will first need to disable the password function using
the old password (see above for instructions). You can then create a new password.
“Keypad Tone”
Keypad tones are enabled by default. You will hear a short beep each time a button is pressed. If you do not wish to
hear this beep, you can use this option to disable keypad tones.
“LCD contrast”
Use this option to increase/decrease the display contrast to suit the ambient brightness or the angle of view.
“Mode”
There are 3 modes:
Nor
(normal),
MA
(MASTER),
SLA
(SLAVE)
• Normal: Turn off PC communication
• Master: No function
Slave: Connect to PC software.
“Net address”
If more than one identical soldering station is connected to a computer, this function must be used to configure a dif
-
ferent address for each soldering station.
“Factory default”
When you select this menu option and press the “MENU/ENTER” button, a prompt will be displayed asking whether
you wish to reset the soldering station to the factory settings. Select “YES” to reset all settings to the factory defaults.
“Exit”
Use this menu option to exit the system menu (alternatively, wait a few seconds without pressing any buttons).
Summary of Contents for 2108748
Page 26: ...26 ...
