background image

Operation

  Do not operate the lamp without the protective cover over the light source, or when 

the protective cover is damaged.

 

Always cover the glass lens with the lens cover when the lamp is not in use. Strong 

sunlight that shines through the magnifying glass can result in the burning glass 

effect and may cause a fire. 

 

Check whether the available mains voltage is appropriate for the voltage range 

indicated on the lamp. 

1.  Lay the connection cable so that nobody can trip over it.
2.  Plug the mains plug into a wall mains socket.
3.  Switch on the lamp using the switch on the top of the lamp.

Position ‘O’: Lamp is switched off. 
Position ‘I’: Lamp is switched on. 

Tips:
•  Arrange your chair, table and the lamp in a convenient and comfortable position to avoid 

eye strain and a stiff neck. 

•  Use both eyes, which should be 20 to 25 cm away from the lens, and move the object 

closer to or further from the lens until the image is clear. Wear spectacles if you normally do.

Changing the light source

  Never use light sources with a greater output than stated in the technical data, 

otherwise the lamp may be overloaded.

1.  Disconnect the lamp from its power supply (pull the plug out of the socket).
2.  Let the bulb cool down to room temperature. CAUTION! Risk of burns.
3  Loosen the 8 screws and carefully remove the protective cover on the rear of the lamp 

head.

4.  Carefully remove the defective bulb from the brackets.
5.  Disconnect the plug from the bulb.
6.  Proceed in reverse order to insert the new bulb.

Care and cleaning

  Do not use any aggressive cleaning agents, rubbing alcohol, or other chemical 

solutions as they can cause damage to the housing and functioning of the product.

 

Avoid touching the lens with your fingernails or other sharp objects.

1.  Disconnect the lamp from its power supply.
2.  Blow off loose particles using clean compressed air, and then brush the remaining debris 

away with a fine lens brush.

3.  Wipe the surface with a lens cleaning cloth or a clean, soft, lint-free cloth. In the case of 

fingerprints or any other grease, the cloth may be moistened with water or lens cleaning 

fluid.

Disposal

  This symbol must appear on any electrical and electronic equipment placed on the 

EU market. This symbol indicates that this device should not be disposed of as 

unsorted municipal waste at the end of its service life.

Owners of WEEE shall dispose of it separately from unsorted municipal waste. Spent batteries 

and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed 

from the WEEE in a non-destructive manner, must be removed by end users from the WEEE in 

a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free takeback 

of waste. Conrad provides the following return options free of charge (more details on our 

website):
•  in our Conrad offices
•  at the Conrad collection points
•  at the collection points of public waste management authorities or the collection points set 

up by manufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of. It 

should be noted that different obligations about the return or recycling of WEEE may apply in 

countries outside of Germany.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-

cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data 

processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication 

represent the technical status at the time of printing.
Copyright 2022 by Conrad Electronic SE. *2435419_v3_0222_02_dh_m_4L

Technical data

Operating voltage ......................... 220-240 V/AC, 50 Hz
Tube ............................................. 22 W, G10q, T5 (available under Item no. 2472609)
Lifetime ......................................... 9000 hrs. 
Lumen ........................................... 900 lm 
Colour temperature ....................... 6400 K (cool white)
Magnification ................................ 1.75x, 3 dioptres
Lens diameter ............................... 125 mm
Cable length ................................. approx. 1.5 m
Operating temperature ................. -5 °C to +40 °C
Arm length (min./max.) ................. Approx. 40 cm / 80 cm
Weight .......................................... approx. 1.8 kg

Summary of Contents for 2435419









Reviews: