28
10. Troubleshooting
In purchasing the cordless drill / screwdriver, you have acquired a product which has been designed to the state of the art and is operationally
reliable. However, problems and faults can occur. Therefore at this point we would like to explain to you how you can rectify possible faults.
Observe all safety instructions contained in these operating instructions without fail!
Problem
Possible solutions
Device not functioning
Is the accumulator empty?
•
On/off switch cannot be pressed
Set the turn-over switch to the position left or right. In the central position it blocks the on/off
•
switch!
When drilling a drill progress
cannot be observed.
Check the sense of rotation of the drill, switch the turn-over switch to the other position.
•
Use another drill.
•
For unscrewing or tightening
a screw the cordless drill /
screwdriver vibrates.
Adjust the torque-setting ring in such a way that the required torque is available
•
Only slow rotation of the drill
chuck
Is the accumulator weak?
•
Drill chuck loose
Tighten the Allen head screw inside the chuck using an Allen key.
•
11. Technical Data
a) Plug charging set
Operating voltage:
220 V~240 V/ 50Hz
Output voltage:
10.8 V=
Power consumption:
1.00 W (Standby), 74 W max. (Charging)
b) Cordless drill with installed accumulator
Accumulator:
B1233L
-Voltage:
10.8 V=
-Type:
Li-ion
-Capacity:
1.3 Ah
Charging time:
~15 mins
Operating time:
~12 mins (fully charged battery)
Current consumtion:
~12 A
Torque levels:
20
Max. Torque:
27 Nm
Speed levels:
2
No load speed:
0-345 / 0-1240 rpm
Chuck capacity:
10 mm
Dimensions:
61 x 215 x 210 mm
Weight:
1170 g
c) Vibration / noise development
Sound pressure level:
72 dB(A)
Sound power level:
83 dB(A)
Acceleration:
1.253 m/s
2
