29
Assignment of Function Buttons
The digital soldering station permits saving three frequently used temperatures on
three function buttons. This makes it unnecessary to set them via the temperature
controller.
The buttons are pre-programmed in the factory and can be freely assigned.
Proceed as follows for re-assignment:
• Push the desired PRESET button and hold it down.
• After approx. three seconds, the display shows the fol-
lowing (PS2 = PRESET 2):
• Set the desired temperature with the temperature con-
trollers.
• The upper value behind PS1 / PS2 / PS3 shows the target temperature for the
respective storage slot.
• After releasing the PRESET button, the new value is saved. Repeat this for the
other buttons.
• The saved values are retained after deactivation.
Switching Display Value between Degrees Celsius
(°C) / Fahrenheit (°F)
Proceed as follows for switching:
1. Push the desired “PS3” = PRESET 3 and hold it down.
2. Switch on the soldering station.
3. If the station was last used in °C, the display will now show “SEL: °F“ = Selected
Mode °F
4. Switch the station off - and on again after approx. 2 seconds.
The station now works with °F values in the display.
If you want to return to °C operation, repeat the process (step 3 will then display
“SEL: °C“).
