13
/
27
13
The welding machine control panels as above shows are used for functions selection and
parameter enactment. It includes figure display window, adjustment knob and LBD
indicator light..
NOTE: THE LEB INDICATOR LIGHT ILLUMINATION SHOW THE STATE YOU ARE
CHOOSING AT THAT MOMENT.
NAME EXPLANATION:
1. GAS PRE-FLOW——Time of ahead
gas sending as you prepare to
welding.
2. STARTING AMP.——starting current.
3. CURRENT UP SLOPE——time slot
for welding current increasing
4. WELDING AMP.——Welding current
in the constant current output estate.
5. PEAK AMP.——the peak value
current when pulse outputting.
6. PULSE WIDTN——Time proportion of
peak value current when pulse
outputting, which controls the welding
line deep and realize entire position
welding and sheet welding.
7. PULSE FREQ——Working frequency
when pulse outputting.
8. AC FREQ——Output frequency of AC
working.
9. CLEAN
WIDTN——the
time
proportion of minus direction current
within one AC welding cycle.
10. CLEAN SCOPE——the percentage of
minus direction current scope adding
when AC welding.
11. BASE AMP.——the maintaining arc
current when pulse outputting.
12. CURRENT DOWN SLOPE——time
slot for welding current decreasing.
13. FINAL AMP.——the welding current
3
#
1#
2#
4
#
6
#
5
#
Summary of Contents for 597077
Page 1: ...1 27 1 ...
