9
/
27
9
piece of equipment can safely operate.
This ADVAN WELDER has a 35% duty
cycle at maximum welding output,
which means that it continuously operates
for 3.5 minutes at maximum output during
a 10 minute period.
CAUTION
: Failure to observe the duty
cycle limitations of this Plasma Cutter can
easily damage this equipment, and will
void warranty.
UNPACKING
When unpacking, checks to make sure the
following parts are included.
Inverter welding machine with
TIG torch with Power Cord
Ground Cable with Clamp
Back-up Accessories for torch
Warranty Card
If any parts are missing or broken, please
call
………
..at the number on the cover of
this manual.
Please keep these two cards (Especially
the serial number on them) well for your
after-sales service.
Preparing Your Work Area
1. You must have a sturdy work table
that is open below the area you are
cutting. Molten slag will be blown
through the work metal, and must be
able to fall away freely
2. Your work table must allow the work
metal to be firmly clamped to prevent it
accidentally falling or moving.
3. The floor and surrounding area of your
work site must not be flammable. A
clean cement floor is recommended.
The cutting process will eject molten
metal slag onto the floor, and it will
scatter for 8-10 feet or more in any
direction. Have an adequate fire
extinguisher available if needed.
ASSEMBLY
Grounding the tool:
Attach a ground wire (not supplied) to the
screw in the lower right of the back of the
tool case. Connect the other end of the
wire to an appropriate ground, such as a
steel workbench, steel biding member or
grounding electrode.
Attaching the Air
WARNING:
Only use dry Argon as the gas
in this tool. Use of any other gas, such as
oxygen, acetylene, etc. may cause
explosion.
Power Switch
Cooling
Fan
Air inlet
Summary of Contents for 597077
Page 1: ...1 27 1 ...
