TM 76025
English
www.toolland.eu
8
shown.
Tighten screw firmly.
To remove the guard, proceed in reverse
order.
Never use the machine without guard.
MOUNTING AND REMOVING A GRINDING
WHEEL
Place the machine on a table, guard up.
Fit the spacer onto the spindle.
Place the grinding wheel on the spacer.
Screw the tension nut onto the spindle.
Press the lock knob and firmly tighten the
tension nut using the spanner supplied.
Release the lock knob.
To remove the grinding wheel, proceed in
reverse order.
Prior to mounting or removing a grinding
wheel always unplug the tool.
MOUNTING AND REMOVING THE SIDE
HANDLE
Tighten the side handle in one of the
mounting holes.
SWITCHING ON AND OFF
To run the machine, slide the on/off-
switch in the direction of the grinding
wheel.
To switch off the machine, you slide the
on/off-switch back.
CLEANING AND MAINTENANCE
The machine does not require any special
maintenance.
Make sure that the ventilation openings
are kept clean. Especially when working
in a dusty environment.
Before removing dust always unplug the
tool.
Do not use brushes of metal or the like to
remove dust and avoid damaging the
internal parts.
TECHNICAL DATA
Voltage
V
230
Frequency
Hz
50
Power
W
500
No-load speed
Min-1
11000
Wheel diameter
mm
115
Grinding
Spindle thread
M.14
Weight
kg
1,90
Level of sound pressure measured according
to EN 60745 :
Lpa (sound pressure)
91,1dB(A)
k=3dB(A)
Lwa (Acoustic power) 102,1dB(A)
K=3dB(A)
Take appropriate measures for the protection
of hearing.
GUARANTEE
Refer to the enclosed conditions for the terms
and conditions of guarantee.
ENVIRONMENT
Should your machine need replacement after
extended use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
