TOOLMATE 40.101.52, Instruction Manual

7.1 Cleaning

Keep the safety devices free of dirt and dust as
far as possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure. 

We recommend that you clean the appliance
immediately after you use it. 

Clean the appliance regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance. 

You must disconnect the hose and any spraying
tools from the compressor before cleaning.  Do
not clean the compressor with water, solvents or
the like.

7.2 Condensation water

The condensation water must be drained off each
day by opening the drain valve (11) (on the floor of
the pressure vessel). 



Important! The condensation water from the

pressure vessel will contain residual oil. 
Dispose of the condensation water in an
environmentally compatible manner at the
appropriate collection point.

7.3  Safety valve (10)

The safety valve has been set for the highest
permitted pressure of the pressure vessel. It is
prohibited to adjust the safety valve or remove its
seal. Actuate the safety valve from time to time to
ensure that it works when required. Pull the ring with
sufficient force until you can hear the compressed air
being released. Then release the ring again. 

7.4 Storage



I mportant! 

Pull the mains plug out of the socket and ventilate
the appliance and all connected pneumatic tools.
Switch off the compressor and make sure that it is
secured in such a way that it cannot be started up
again by any unauthorized person. 



Important! 

Store the compressor only in a dry location
which is not accessible to unauthorized persons.
Always store upright, never tilted! 

8. Ordering replacement parts

Please quote the following data when ordering
replacement parts:

Type of machine

Article number of the machine

Identification number of the machine

Replacement part number of the part required

For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.

The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.

UK

23

Original operating instructions 

Anleitung_TMAC_160_OF_SPK7:_  08.04.2011  8:58 Uhr  Seite 23