25
GB
Instructions - Step 1
1
6
5
4
3
2
1
6
5
4
3
2
Select a flat surface for the tent. Unpack the boxes and check if all listed parts are included.
Remove the slight oil film from the pipes with a cloth. In colder weather conditions we sug
-
gest to bring the roof to room temperature before installing.
Make sure that the wing nuts are always facing the inside when assembling.
Place the triangular arches (2) as shown on the ground.
Connect the triangular arches with the roof struts (7 und 8). Make sure that 8 is the last strut.
Now connect the roof bar (3) with the roof arch (2) and screw the roof strut (4) together with the
roof bar (3). Use the screws (18) and the wing nuts for this (20).
7
Connect the side arches (1) with the roof bar (3). At least one person should hold the frame upright.
Now connect the side arches (1) with the side struts (7 and 8) using the screws and nuts (18 and 20).
Make sure that the last strut used is always 8. Close the endpipes 7 and 8 with the corresponding pla
-
stic caps (35).
Put the middle leg (5) in the side arch (1). Now join the side struts (7 and 8).
Secure the frames accordingly and put the lower leg (6) in the middle leg (5).
Instructions - Step 2
Assemble all of the connecting frames accordingly.
Now assemble the frames individually on the finished sections with the side struts (7). For this step you
will need ladders and several persons. Please, use only the side strut (7) for connecting the next section.
Repeat position 2 with all frames and follow exactly the construction and correct order (see position 1).
Connect the feet in the lower part of the legs and secure the frame with ground pins 16 and
ground pins 26 on the ground. If necessary, use the ground clamps.
Pull the tarpaulin over the frame.
Pay attention especially to the edges and corners of the frame to avoid damaging the tarpaulin.
Push the tension bars (9) in the provided pockets and use the fasteners. Assemble the gable walls
with the elastic rings (17).
