Customer Helpline
1300 889 028
10
Operating Instructions
NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for the fastening and loosening of bolts, nuts and various threaded fasteners.
This tool is not intended for use as a drill.
BEFORE PUTTING INTO OPERATION
1. CHARGER
A) CHARGING THE BATTERY (SEE FIG. A1&A2&A3)
a) The battery in your new tool is not charged when it leaves the plant. Therefore it must be
full charged before using the first time.
b) Do not use any charger other than that specifically provided for use with the equipment.
c) If the battery pack is very hot you must remove your battery pack from the charger and
allow time for the battery to cool down before recharging.
d) Please charge the battery to reach full or no less than half charge before storage. If the
tool will not be used for long periods of time, charge the battery every 3-6 months.
B) CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, make sure the battery is in the correct charge
position firmly. The light will turn to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green.
4) When fully charged, unplug the charger and remove the battery pack.
Note: If the battery pack is locked in the charger, press the battery pack release button
and remove it.
WARNING: When battery charge runs out after continuous use or exposure to
direct sunlight or heat, allow time for the tool to cool down before re-charging to
achieve the full charge.
