Customer Helpline
1300 889 028
11
Operating Instructions
BEFORE PUTTING INTO OPERATION
1. BEFORE USING YOUR CORDLESS TOOL
WARNING:
The charger and battery pack are specially designed to work together so do
not attempt to use any other devices. Never insert or allow metallic objects into your
charger or battery pack connections because of an electrical failure and hazard will occur.
The Li-Ion battery is protected against deep discharging. When the battery is empty, the
tool is switched off by means of a protective circuit: The tool holder no longer rotates. In
a warm environment or after heavy use, the battery pack may become too hot to permit
charging. Allow time for the battery to cool down before recharging.
When the battery pack is charged for the first time and after prolonged storage, the
battery pack will accept a 100% charge after several charge and discharge cycles.
2. TO REMOVE OR INSTALL BATTERY PACK (See Fig. E1, E2)
Press the battery pack latch and remove the battery pack from the sander. After recharge slide
the battery pack into sander’s battery port. A simple push and slight pressure will be sufficient.
3. HOW TO CHARGE YOUR BATTERY PACK (See Fig. F)
Charging procedure
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the
charging process has started.
3) When charging is completed, the light will turn to green. The pack is now fully
charged, unplug the charger and remove the battery pack.
WARNING:
When battery charge runs out after continuously use or exposure to
direct sunlight or heat, allow time for the tool to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems that can arise with battery packs.
Indicator lights indicate problems (see table below). If this occurs, insert a new battery
pack to determine if the charger is OK. If the new battery charges correctly, then the
original pack is defective and should be returned to a service center or recycling service
center. If the new battery pack displays the same problem as the original Battery Pack,
have the charger tested at an authorized service center.
E1
E2
Summary of Contents for CPS18LD.9
Page 16: ......
