2 |
LACEnano user manual
ENG
Thank you
for showing your support by
getting your very own LACEnano.
The LACEnano is a brushless rotary tattoo machine
with a magnetic drive, so it will feel a lot like a coil
machine but without the hassle and the weight. It is
also the lightest tattoo machine in the world weighing
in at only 46g/1.6oz.
LACEnano needs a special power supply that comes
with every machine. This is because of the
brushless
motor
. The LACEnano will not work with standard
power supplies (actually they might hurt the machine
so don’t try it) and other tattoo machines will not work
with the LACEnano power supply.
You also get an international wallwart in the kit; it
has 3 interchangeable wall plugs for when you go to
conventions abroad. The Power supply is pretty self
explanatory; all the connections are different from
POWER SUPPLY
each other, so there is no way of plugging things in
the wrong way. The knob controls the speed of the
machine from 2500 RPM to 8000 RPM (42 Hz to 133
Hz). This is a constant voltage power supply; the
wizardry inside it will adjust the pulses to the motor
and keep the motor spinning at the set speed if the
load increases (if you push harder or put on a bigger
needle). So no more guessing and adjusting the
voltage. This is how brushless motors work.
In the picture bellow are the front and rear panel of
the power supply; You plug the wall wart in to port
(A)
, your footswitch into port
(B)
and the machine
into port
(C)
.
(D)
is the RPM control knob.
