3 |
LACEnano user manual
ENG
The LACEnano has a finger clamp that will take
any
standard 8mm tube/grip
. It will not crush the
tube like some other guillotine type tube holding
mechanisms do.
This being a magnetic drive machine, it will not work
well with cartridge needles (much like coil machines
don’t because of the magnetic transfer of force)
for this reason we do not recommend the use of
cartridge needles.
The settings are really simple and can be done on
the fly without any tools and while tattooing using just
your fingers. The point here is to control the position
of the magnet on the armature bar in relation to the
one spinning on the motor.
The
upper thumbnut
(2)
controls the hit. You adjust
it up for a harder hit and down for a softer hit.
The
lower thumbnut
(3)
controls the stroke. You
increase the stroke by moving it down and decrease
the stroke by moving it up.
THE MACHINE
The
jack
(1)
is where you plug in the LACEnano power
cable.
It is best to use a thin, small diameter rubber band.
Hook it on the
backpost
(4)
, stretch it over the needle
loop around the machine and hook it on the backpost
from the other side as seen in the diagram.
