4 |
LACEnano user manual
ENG
The machine might get hot
, if you run it at full speed
and with a hard hit for long periods of time without
any brakes. This is not a problem for the machine, but
it might be too hot for your hands if you touch it right
away. For this reason we advise you to use a tattoo
pedal that turns off everytime you remove your
foot
so the machine has a few seconds to cool off.
Also; make sure to give it a few moments after you
are done tattooing before you touch it.
This phenomena is common in coil machines and
the reason for it is the high power of the machine. A
small rotary will not get so hot, because it only has a
5w motor, but coils produce much more power (and
heat) and the
LACEnano has a 40w motor
, so it does
give off some heat.
It is common for artists to use a short stroke for lining
and a long stroke for shading. This is probably what
you have been taught or you may have developed
your own technique to achieve the results you are
after. Nothing is set in stone and it is advisable to set
the machine individually for every skin type, needle
ADJUSTMENT POINTERS
size and technique combination. The LACEnano is not
a one trick pony.
1
3
4
2
Put the needle you are going to use on the
machine as well as a rubber band if you are
going to use one.
Adjust the give with the upper thumbnut but
make sure that the magnets are not touching
or even hitting each other when the machine is
running! The ballpark is up to 2 full turns down
from the upper most position of the thumbnut.
And now adjust the stroke with the lower
thumbnut; the best useable strokes are from
2.5-4.5mm at the needle.
Adjust the speed on the power supply first.
THIS IS HOW YOU ADJUST THE MACHINE
(it might be a little counterintuitive):
