Toolson 3901208958 Instruction Manual Download

Page: 18 / 180

18 І 180

• Cracks through aging of insulation.

Such defective electrical connection cables must not be

used as the insulation damage makes them

extremely

hazardous.

Check electrical connection cables regularly for damage.
Make sure the cable is disconnected from the mains
when checking.
Electrical connection cables must comply with the regu-
lations applicable in your country.

Single-phase motor

•

The mains voltage must coincide with the voltage
specified on the motor’s rating plate.

•

Extension cables up to a length of 25 m must have a

cross-section of 1.5 mm2, and beyond 25 m at least
2.5 mm2.

• The connection to the mains must be protected with

a 16 A slow-acting fuse.

Only a qualified electrician is permitted to connect the

machine and complete repairs on its electrical equip-
ment.

In the event of enquiries please specify the following

data:
•  Motor manufacturer
•  Type of current of the motor
•  Data recorded on the machine’s rating plate
•  Data recorded on the switch’s rating plate
If a motor has to be returned, it must always be dis-

patched with the complete driving unit and switch.

•

Unlock the movable saw blade cover (7) by pressing

the blocker 3 (Fig. 1).

•

When doing so lift the saw blade cover (7) to free the
saw blade (8).

•

Push the saw blade blocker A (fig. 7.1) until the saw

blade locks in place.

•

Loosening of the saw blade fixing screw with the pro

vided socket wrench (B) (Attention, left-hand thread).

•

Remove screw and saw blade flange.

•

Remove the saw blade carefully. Attention: Danger of

injuries from the saw blade.

•

Set the new saw blade on the inner saw blade flange
observing the correct size and rotational direction of

the saw blade.

•

Attach the outer saw blade flange and tighten die
screw firmly.

•

Set the saw blade cover back to the correct position.

Maintenance

WARNING: For your own safety, turn the switch off
and remove the plug from the power source outlet
before maintaining or lubricating your mitre saw.

General Maintenance

Occasionally use a cloth to wipe off chips and dust from

the machine. Oil the rotary parts once a month to extend

the tool life. Do not oil the motor.

Brush Inspection

Check the motor brushes after the first 50 hours of use
for a new machine or after a new set of brushes have
been installed. After the first check, examine them every

10 hours of use.

When the carbon is worn to 6 mm in length or if the

spring or shunt wire is burned or damaged, replace both

brushes. If the brushes are found serviceable after re

moving, reinstall them.

Electrical connection

The installed electric motor is completely wired

ready for operation.

The customer’s connection to the power supply sys-
tem, and any extension cables that may be used,

must conform with local regulations.

Important remark:

The motor is automatically switched off in the event of
an overload. The motor can be switched on again after a
cool ing down period that can vary.