EN
15
3.
Mount the drive with the 4 screws from the bottom as
seen infollowing illustration.
4.
Fasten the 2 screws on the rear panel to finish the
assembly.
5.
Connect the USB type B male conector of the cable to
the USB of the case.
6.
Connect the AC/DC power adapter.
7.
Connect the USB type A male connector og the main
cable to the computer’s USB 3.0 PORT. If the cable is
connected to a USB 2.0 or usb 1.1 port, the transfer speed
will down to 480 Mbps or 12 Mbps.
8.
Connect the power cable to the mains socket.
9.
Turn on the enclosure by putting the power switch to
position “ON”.