Step 4
Loosen the four screws (G-2) and four
washers (E-3).
Connect the tension control upper (C-2) &
lower (G-4), connect the sensor cable upper
(C-1) & lower (G-3).
Insert handle bar post (C) onto the support
tube, tighten with four screws and washers.
Step 5
Put the handle bar (B) into the metal
bracket, make the hand pulse cable
through the hole on handle bar post, cover
the bracket with the plastic cover, use flat
washer (B-5), spring washer (B-6), bushing
(B-7) and T-knob to fix the handle bar as
the right drawing.
7
