16
will show “REPLACE BELT” after 50KMS
Oil adding reminding
replaces belt reminding
Maintenance and Malfunction Treatment
1) Clean: The surface of the treadmill should be kept
clean, pull out the power line before cleaning. You
can clean the running belt and the surface of the
treadmill with a soft and wet cloth.
2) Adjust belt deviation: The running belt is adjusted
at factory; it may runs defectively after
transportation and use. Turn off the treadmill before
adjusting, (see figure) adjust the pull the left and
right bolts in rear roller with hex spanner. If the belt
is deviation to left, clockwise rotate the left bolt. If
the belt is deviation to right, counterclockwise rotate the right bolt. It is better to adjust 1/2
circle
once.
Then
turn
on
the
switch,
check
if
the
belt
runs defectively when the running speed is 4~5 km/h. Repeat to adjust to the belt in the center.(see
figure)
3) Adjust belt slip: After using for a long time, the belt may be longer and stuck. Your should adjust the
left and right bolts in rear roller clockwise at same position till the runs smoothly and freely, it is
better to adjust 1/2 circle once .But avoid to short belt using period of losses, doing not to adjust it
too tight.
