Blender Jar Assembly
2
Important safety advice
To avoid electric shocks, do not use this device in the vicinity of water. Do not
immerse the mains lead in water or other liquid.
Please read through the information and safety advice contained in these
operating instructions carefully and thoroughly before you use the stand mixer
for the first time.
Do not kink or clamp the mains lead. To avoid any risk of stumbling, do not
allow the mains lead to hang over the edge of a table or a counter.
Make sure that the voltage shown on the rating plate corresponds with that of
the mains supply. The rating plate can be found on the bottom of the motor
block. The stand mixer is only to be connected to an AC supply (~). The motor
must always be switching off before the stand mixer is connected with the
mains supply.
(Switch (8)
in the “0” setting).
Do not use outdoors. Only suitable for use indoors.
This device should not be set up in close proximity to a naked flame, easily
flammable materials (curtains, textiles, etc.), a radiator, an oven or some other
heat source.
Before use, place the device on a horizontal and flat surface.
Place this device as close as possible to the power source so that you can
disconnect the plug quickly and easily.
The device must be operated with the type of power specified on the rating
plate. If you are unsure about the details of the available power supply, ask your
dealer or the local power supply company.
Do not attempt to repair the device yourself, since you will be exposed to
hazardous live components or other hazards by opening and removing the
covers.
Repairs should only be carried out in a qualified workshop.
This is not a toy! Keep away from children. The device should be used and
stored out of the reach of children.
Careful supervision is required when the device is used by or in the vicinity of
children.
3
1 Measuring cup
2 Lid
3 Glass Jar
4 Jar base
5 Sealing ring
6 Blade base
