The device should only be used for its intended purpose.
Never operate empty and without supervision.
During use, do not touch moving parts with your fingers.
Please note that when passing the device on to a third party, the operating
instructions must be included.
No liability is accepted for damage due to improper use or the failure to observe
our operating instructions / safety notes.
Unplug the appliance when not in use or before cleaning.
If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
The blades are very sharp. Be careful while clean the jar.
Switch off the appliance and disconnect from supply before changing
accessories or approaching parts that move in use.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
Do not use mixing, mincing and blending function at the same time. Only use
one of them at a time.
Technical information
Voltage/frequency: 230-240V ~ 50/60Hz 800W
Agitator kettle capacity: 5.2liters
Glass jar capacity: 1.5 liters
Before first use
All parts of the food mixer are to be thoroughly cleaned before being used for
the first time. (See section: Cleaning).
Take out the required length of cable from the cable tidy on the base of the food
mixer and connect the device to the mains supply.
4
Assembly of the Glass jar
1. Mount the jar sealing ring onto the blade base ,and Mount the blade base into
the jar base, and the inside ring of jar base is tighten on jar base as far as fixed
the blade base tight.
2. After putting the ingredients in the jar, fix the lid onto the jar by pressing down.
3. Insert the Measuring cup into the opening of the lid, and tune it in anticlockwise
direction until it is locked.
4. Mount the jar with jar unit onto the main base, and tune the jar in anticlockwise
direction until the jar is locked.
Trial use
1. Revolve the Shaft knob, then lift the machine arm.
2. Put the mixing bowl and mixing bowl cover onto the base, and lock it as the
arrowhead denotes.
3. Revolve the Shaft knob, then push the upper cover down and make the arm
down. Make sure the arm is fixed together the base, then Revolve the Shaft
knob up to lock the arm solidly.
4. Plug-in the cord, and turn the switch to P, then try every speed for a few
seconds.
5. After the trial, turn the switch to Speed 0.
6. Turn the Shaft knob and lift the arm, then take apart the mixing blade from the
blade conector.
7. Take off the back cover from the upper housing.
8. Pure a cup of water into the blender jar, set the blender jar onto the machine,
then repeat step 4, 5 and 6.
9. Take off the blender jar, and set the Caudal cover to the machine.
Operation Guide
To mix or knead dough:
1. Suggestion flour and water at a ratio of 2
：
3.
2. From speed 1 for mix 20 second, and speed 2 for mix 20 second, afterwards
speed 3 for about 3 minutes.
3. When filling the blender jar, please ensure that the maximum quality is not
exceeded.
4. Maximum quantity of flour is 1500g.
5
