20
MAIN POWER CONNECTION
Step 5.
Connect the main power connections
The 12VDC/24VDC connection is the main power supply for the
system. It gives electric power to all the components in the system.
The power should be connected by using an eyelet mounted with
an M10 bolt and nut onto the main connections. These connections
must be mounted tight to prevent the connections form heating up
and causing hazardous situations.
It is obliged to also clamp/support the electric wires of the main
connection onto the chassis or any other solid component of the
vehicle near the main connection, to prevent them from moving or
vibrating and applying forces onto the connections that can
possibly damage them.
Main power connection
The connection can also be covered by two eyelet covers. Whether
to use a 12VDC or 24VDC power supply depends on the type of
ECO-ClimaTEC.
The ECO-ClimaTEC works with high currents while operating due to
the high power on low voltage. To make sure the system will
operate efficient and non hazardous it is important to choose the
correct wire thickness for the main connections. Following table
