Page | 21
Safe Driving
When driving on ramps, high curbs and on sharp turns, drive very
slowly and carefully, preferably with the speed set to MIN.
When going up or down a step, always drive so that the wheels are
fully perpendicular to the step and both of the rear wheels meet the
step at the same time.
Never try to go on an obstacle that is more than the maximum
recommended slope or curb height (see the stabilities and the
obstacle climbing specifications given in the specification Sheet)
Always drive carefully and adjust your speed to the road conditions.
Before making sharp turns, reduce speed to minimum to prevent side
roll-over.
Climbing an
obstacle
To climb an obstacle, drive the TG400RS forward toward the obstacle
until the front wheel touches the obstacle, then, maintaining your
direction, increase speed.
Prior to use
After reading through this entire manual and before using the
TG400RS, do a visual check of all the parts of the vehicle, to make
sure that there is no visible damage. If you have any questions or
concerns, contact your dealer.
Program
Controller
Several parameters of the TG400RS controller can be programmed.
Programming must be done by trained authorized technician only.
Incorrect programming can cause abnormal operation of the
TG400RS and may result in damage and personal injury.
Prior to use
Before using the TG400RS, be sure you know your own weight and
the weight of any items you will be carrying on it. The maximum total
load is 150kg (330lbs).
Performance
Check
A performance check is highly recommended when you first receive
Your TG400RS or after a period of not using the TG400RS, as
follows:
1. Turn on the key switch.
2. Verify that both the ON LED and the battery status indicator
are lit.
3. Slowly squeeze the drive control lever and verify that the
TG400RS travels at a speed that corresponds to the degree to
which you are squeezing the lever.
4. Release the throttle control lever and verify that the TG400RS
stops smoothly, and that you hear the click of the EMB
engaging.
5. Check that all the buttons on the dashboard work correctly.
6. Switch off the key switch.
Your TG400RS is now ready to drive.
Summary of Contents for TG400RS
Page 25: ...Page 24...
