Page | 22
CHAPTER 5 - CHARGING THE TG400RS BATTERIES
Read the charger manual before using it.
Warning: If you use a charger other than the one supplied with your
TG400RS ask your dealer for instructions.
CHARGING BATTERIES
(see Figure C)
1) Insert the charger plug (8) in the charging socket (10) located on the right
side of the tiller column.
2) Plug the charger power cord (9) into a wall socket (11).
3) When charging is complete, remove the charger power cord (9) from the
wall socket (11) and then remove the charger plug (8) from the charging
socket (10).
4) Under ideal storage conditions, batteries that were charged to full
capacity and were not used should be recharged every month
5) If you expect not to use your
TG400RS
for an extended period of time, we
recommend charging it for two days and then disconnecting the batteries.
6) If you have not used your
TG400RS
for an extended period of time,
charge the batteries for at least 24 hours before driving.
Note:
•
There is NO need to disconnect the charging plug immediately after the
charging is complete.
•
However, DO NOT leave the charger connected to the batteries FOR
MORE THAN TWO WEEKS.
•
As long as the charging plug is in the charging socket, the electronic
control of the TG400RS automatically cuts all power to the electric
system and it cannot be driven.
•
The charger supplied is suitable for charging lead acid dry/gel batteries.
Use only the defined type of charger. Before using any other type of
charger, check with your dealer.
MAINTENANCE
FIGURE C
Summary of Contents for TG400RS
Page 25: ...Page 24...
