p
Step 9
Use Epoxy to install the fi rewall onto the
fuselage. Use masking tape to assure
good contact between all parts. Note
that 1-1/2° of right thrust is built into the
fi rewall.
p
Step 10
Test fi t the fuselage top and then use
an adhesive that will give you time to
pull the top and sides snugly together
and hold it there with masking tape until
cured, such as aliphatic resin. Now glue
F-4 permanently into position.
p
Step 11
Glue on the 1/8” Balsa wing saddle
doublers and then snap the wing mount
plates temporarily into position. Draw
a line along the fuselage side onto the
wing mount plates.
p
Step 12
Trim the fl anges of two #1/4-20 blind nuts
to the line as shown and install them into
the wing mount plates. Be sure to make
one left and one right. Then Epoxy these
plates into the fuselage sides with the
blind nut fl anges facing the top of the
fuselage.
3
Summary of Contents for SPUNKY
Page 1: ...SPUNKY ASSEMBLY MANUAL...
