2
、
Transmitter (Mode 2 for example)
Remark
：
We have already installed the integrated DSM2 compatible receiver mould, please prepare
the proper 6CH transmitter
（
compatible with DSM2 receiver
）
for flight.
Default: SWA/B
SWB-0
(Sixth Channel)
SWB-1
(Sixth Channel)
SWB-2
(Sixth Channel)
SWA-0
(Fifth Channel)
SWA-1
(Fifth Channel)
SWA-2
(Fifth Channel)
Stand by
Headfree
Stand by
ANGLE
HORIZON
AIR MODE
Angle
：
The horizontal flight is kept by the assistance from Gyro and Accelerator at the same time. Any
front/back/left/right movement need to be controlled manually.
Headfree
: Under headfree mode, the direction of the flight is only recognized as the same as the direction of
spark when you are into this mode.
Stand By
: No function
Horizon
：
The flight is controlled with the assistance from Gyro only. Any front/back/left/right movement need
to be controlled manually. The operation angle is 50% higher than Angle mode.
Air Mode
：
It is better to operate this mode under Horizon Mode. Under this mode, the propeller will be rotating
idle when the throttle is at the lowest position by PID algorithm.
Instruction (Mode 2 for example)
1. Power on the aircraft
Please use 1S Li-Poly battery with full charged.
The capacity of recommended battery in package is 260mAh
Please note the safety weight for taking-off is no more than 36g.
The ESC of Spark is only support 1S (3.7V) battery, please don’t use any battery with higher voltage
2. Install the propeller
Please install the propeller after you finish the binding and testing
1) If the propeller need to be replaced, please install corresponding propellers as marked to the aircraft. Please
lock them by PM2.0*6mm screws. The red arrow in below picture is the head direction.
