3
www.topvehicletech.com
FITTING GUIDE
1. Open the passenger side door and proceed to pull away the door trim from the pillar.
STEREO REMOVAL
DAB ANTENNA INSTALLATION
2. Using a set of panel removal tools, begin to pry away the pillar casing.
4. The DAB antenna not only has a self adhesive backing, but also features a black earth sheet. When
placing the DAB antenna, the earth sheet
MUST
be placed onto the metal part of the pillar. The antenna
itself must be located roughly 15cm from the top of the windscreen.
Note: this antenna must not be placed atop any kind of heating elements, this will interfere with the
antenna’s signal.
5. Once happy with the placement, take the 3m of wiring extension and feed it down through to the
stereo’s opening. With the wiring adjusted to the appropriate length, feel free to re-install the glovebox.
3. The glovebox will need to be opened/removed to route the antennas wiring.
1. Use a bojo tool to unclip the trim panel that houses both the passenger side and left-central air vent.
3. Remove the 4x screws that secure the main stereo.
FASCIA PLATE SET-UP
3. When happy with the alignment, and the “
Stereo Installation
” process is complete, place the stereo
into the dashboard. Once seated correctly, place the fascia plate over the top and screw the fascia to the
cage as well as the dashboard by using the pre-existing screws.
2. Slide the new stereo into the back of the bracket casing and screw into place using the screws within the
kit. Once attached, offer the whole unit to the back of the fascia to gauge the correct alignment.
2. Then use the bojo tool to remove the air vent just between the radio and the steering wheel.
4. With the bottom two screws undone, begin to remove the Porsche branded panel located under the
main radio by lifting and pulling out of place.
5. With this bottom panel removed, ensure the gear shifter is pulled back and begin to pull the main radio
out of place. Once out, disconnect all of the wiring.
1. Start by attaching the clips found within the kit to the back of the new bottom trim. You will also need
to relocate the plastic guide clips from the OEM radio to the relevant spokes found on the bracket casing.
4. Once the fascia is installed, clip the bottom panel into place and re-locate the air vents.