4
www.topvehicletech.com
FITTING GUIDE
STEREO INSTALLATION
9. Attach the additional wiring on the harness to the back of the stereo:
Pink
- Speed Pulse
Purple
- Reverse Gear
Green
- Park Brake
Blue
- Amp Remote
Grey
- Mute
10. When all the above wires (and any additional accessories) have been connected, finally make the
connections between the stereo and the vehicles pre-existing power/stalk connectors.
2. Connect the bullet connector from the stereo patch lead to the ‘steering wheel remote input’ on the
back of the new stereo.
7. Connect the DAB antenna’s SMB connector to the back of the new stereo.
8. Attach the antenna adapter to the vehicles pre-existing connection and the back of new stereo.
1. Take the steering wheel control interface in hand and connect both the 12-way stereo patch lead and
the 14-way steering wheel harness connectors to the corresponding sides.
4. Connect the yellow RCA connector to from the camera extension to the reverse camera input of the
stereo.
To retain factory OEM reverse camera
: attach the yellow female RCA from on the camera extension
harness to the male yellow RCA on the main wiring harness.
To add an aftermarket reverse camera
: attach the yellow female RCA from on the camera extension
harness to the male yellow RCA of the aftermarket reverse camera.
5. Connect the USB retention lead between the vehicles OEM connection and the USB connection from
the stereo.
6. Connect the Red/White RCA connectors labelled ‘AUX’ to the back of the new stereo.
3. Connect the 4-way connector on the camera extension harness to the interface.
BEFORE INSTALLATION - DIPSWITCHES
On this particular interface are a set of dipswitches. These dipswitches have the following properties:
1: OFF - Kenwood.
ON - Pioneer.
2: OFF - NTSC reversing camera (default). ON - PAL reversing camera.
3: Change from OFF to ON to ‘reset’ screen setting to factory default.
Note: during this procedure, the screen background will change to red and no settings adjustments can be made.
4: Not Used.
