3
www.topvehicletech.com
FITTING GUIDE
1. Open the passenger side door and proceed to pull away the door trim from the pillar.
STEREO REMOVAL
DAB ANTENNA INSTALLATION
2. Using a set of panel removal tools, begin to pry away the pillar casing.
4. The DAB antenna not only has a self adhesive backing, but also features a black earth sheet. When
placing the DAB antenna, the earth sheet
MUST
be placed onto the metal part of the pillar. The antenna
itself must be located roughly 15cm from the top of the windscreen.
Note: this antenna must not be placed atop any kind of heating elements, this will interfere with the
antenna’s signal.
5. Once happy with the placement, take the 3m of wiring extension and feed it down through to the
stereo’s opening. With the wiring adjusted to the appropriate length, feel free to re-install the glovebox.
3. The glovebox will need to be opened/removed to route the antennas wiring.
1. Remove both the left and right air vents by using a flat blade. You need to release 6x clips from the
inside of the vents: 2x left, 2x right, 1x top, 1x bottom. These clips are holding the vents firmly into place.
Once out, disconnect the wiring.
3. Remove the 4x screws that secure the main stereo and remove whilst disconnecting the wiring.
2. Before removing the head unit, it is best to put gear shifter in either ‘Drive’ or ‘4th’ gear to allow for
room when removing radio.
FASCIA PLATE SET-UP
3. When happy with the alignment, and the “
Stereo Installation
” process is complete, screw the stereo
into the dashboard using the pre-existing screws. Then re-install the vents either side, re-connecting the
wiring in the process.
1. Attach the brackets to the new stereo using the screws within the kit. With the brackets attached, offer
the whole unit to the back of the fascia to get the correct alignment.
2. Once done, secure the stereo to the fascia panel using the 4x self tapping screws found within the kit.
