16
CORDLESS CAULKING GUN / GLUE GUN
EN
Translation of the original instructions
1.
Firstly untighten and remove the compound holder.
Front Cap
Compound Holder
Fig.8
2.
Loosen M8 Screw (Fig.9) then remove the pushing block and plastic plunger disk (Fig10).
Fig.9
Pushing Block
Fig.10
3.
Screw back on the compound holder then remove the front cap.
4.
Use a sharp knife to cut the tip of caulking tube at least 3 mm in diameter.
This will allow the tool to provide a optima seam width for most of applications.
Fig.11
