46
OPTIONAL OPERATIONS
DISPLAYING MEASUREMENT VALUES
With regard to TONO measurement values, data of the latest three measurements are displayed on
the control panel.
Figures only:
Measurement was done correctly.
[ ] figures:
When the reliability of measurement is low.
ERROR:
Measurement was not done correctly.
OVER:
When the measurement range is exceeded.
DISPLAYING THE PATIENT ID (PATIENT No.) OR OPERATOR ID
A patient ID or operator ID of up to 13 characters can be input and displayed on the control panel
and printout.
However, if no patient ID is input, the patient No. is allocated automatically by the device.
1
Tap
button.
2
Tap keyboard on the screen and enter characters. Tap
button and fix the input value.
NOTE
• Even if an alignment is not correct under auto shoot mode off, the mea-
surement can be performed by pressing the MEASUREMENT switch. To
ensure correct measurement with high accuracy, try to get correct align-
ment.
• Even if you seem to get correct alignment, the alignment mark does not
become . In this case, please carry out a measurement after confirming
surely that the alignment is performed correctly.
• The alignment mark may not become according to patient's cornea
condition.
NOTE
• In TONO average value display, low-reliability numerical data with [ ] are
not added to the average value calculation.
However, if all measurement data are numerical data with [ ], the average
value calculation is done using these data.
• When data is printed out, the "M" mark is printed on the value measured
in auto shoot mode off.
• For explanation of the messages on the control panel screen, refer to
NOTE
• Patient ID is reset when measurement values are printed or if the
button is tapped.
• Patient No. reset condition can be selected such that the patient No. is
reset upon power on or not, in the initial setting of setup screen.
Patient ID
Patient ID
14
[15]
16
14
[15]
16
15
17
14
15
17
14
3
3
3
3
0.499
0.499
15
15
15
15
15
15
15
15
01
01
1
1
0.500
0.500
1
1
TOPCON̲TAROU
TOPCON̲TAROU
Latest data
Data of 2 times ago
Data of 1 time ago
ID
OK
ALL CLEAR
Summary of Contents for CT-800
Page 1: ...USER MANUAL COMPUTERIZED TONOMETER CT 800 ...
Page 2: ......
Page 78: ......
Page 80: ...78 COMPUTERIZED TONOMETER CT 800 41628 95010 Printed in Japan 1402 100LW0 ...