Using the Camera and Compass
GMS-2 Operator’s Manual
4-6
When calibrating the compass, the new calibration is only used until
the GMS-2 is turned off. When the unit is turned on, the default
calibration will be used.
1. To calibrate the compass, tap
Calibration
on the Compass tab.
2. Place the unit horizontally on a flat surface, and tap
Start
at the
confirmation (Figure 4-4 on page 4-6).
Figure 4-4. Begin Compass Calibration
3. Rotate the unit 360° twice, in the same direction as the circling
red dot on-screen. Tap
End
.
Figure 4-5. Calibrating the Compass
ENT
ESC
ENT
C
ESC
SC
ENT
ESC
Rotate Unit
Twice
GMS-2_OM_Book.book Page 6 Friday, December 28, 2007 1:47 PM
Summary of Contents for GMS-2
Page 2: ...ECO 3198 GMS 2_OM_Book book Page 2 Friday December 28 2007 1 47 PM ...
Page 106: ...GMS 2 Operator s Manual Notes Index GMS 2_OM_Book book Page 4 Friday December 28 2007 1 47 PM ...
Page 107: ...Notes Notes ExtraNotes_our fm Page 1 Friday December 28 2007 2 10 PM ...
Page 108: ...Notes Notes ExtraNotes_our fm Page 2 Friday December 28 2007 2 10 PM ...