Intr
oduction
Indicate System Components
2
Excavator Indicate System
P/N: 1022461-01
The TS-i3 Tilt Sensors, the MC-X1 Controller, the GX Series display, and the LS-B10W Laser Receiver
make up the 2D indicate system. The LS-B10W adds a laser height reference, and is calibrated for its
location on the stick of the excavator. The 3D system (Figure 1) utilizes two GR-i3 GNSS Antenna and
a radio module for precise 3D control.
Figure 1: Machine Components
Bucket (Hitch)
Sensor
LS-B10W
Laser Receiver
LS-B10W
Laser Receiver
Body Sensor
Boom Sensor
Stick
Sensor
Stick
Sensor
Radio Module
GNSS Antenna 2X
GX
Series
D
is
p
lay
M
C
-X1
C
ontroller
O
p
tional
D
ogBone
Sensor
P/N: 1015925-01
S/N: 1420-XXXXX
When installing components, use the Topcon supplied fuse or fused power
from the machine of the same rating.
System ground must be connected to the frame side of the ground
disconnect switch, not directly to the negative battery terminal.
